Your attempt to take the test will be viewed by a projector (human) who will mark any violations of the exam rules.
 

Checklist before testing

Important! If you are working on Mac, set your system and security settings according to this guide.

Exam start

Note, the Start option is available 15 minutes before the exam start time. At the same time, the exam itself is available only at an appointed time. Use these 15 minutes to get prepared and finish the equipment check.

Carefully read EULA before proceeding to your exam and confirm your agreement.

Equipment check

In a popup that appears, let Examus access and use your webcam and microphone.

In the next browser popup, you will be asked to share your screen. Just click on the Entire Screen thumbnail and click on where it says Share.

Wait until the equipment check is finished.

Personality recognition

• Make a photo according to a request on your screen.

• Click on where it says Send, after the photo page refreshes.

Important! You might be asked to make your selfy or your ID photo or both (one after another). Just follow instructions on your screen.

Your desk demonstration

While your desk demonstration, take your webcam or your laptop and direct its shooting objective onto your desk. Demonstrate your desk from different sides so that your proctor can see that there are no hidden and/or forbidden equipments put on your desk.

Carefully read the exam rules that will be displayed on your screen.

Let Examus access your clipboard.

During your exam

To expand the Examus panel, click on the chat icon as in the picture below.

The exam panel is movable. Just click on and hold the sandwich option at the top of the panel and move it.

The exam rules are shown under the exam name. Greyed out options are forbidden, whereas green ones are allowed. To see a tooltip for each rule, hover your mouse cursor over each rule icon.

You must stay in front of your webcam throughout your exam.

Click on start option on the page with your assignment and proceed.

Keep in mind that exams may have time restriction. Check on the exam page if there is a stopwatch started.

Completion

If you are ready to submit your answers, click on where it says "Finish and submit" in your LMS.

Note: navigation options may be named differently in different LMSs.

You may see the following message after you submit your attempt.

You will see the uploading process at the lower-right corner.

It is critical to wait for all files to be uploaded.

Important! If you have just finished your exam and you need to proceed to the next one, but only the finished exam is available in Examus and it says Continue, you have to finish the proctoring session for this exam first.

• Click on where it says Continue

• Repeat the pre-exam procedure (EULA, equipment check, etc.)

• In exam, make sure that all your answers are saved and the quiz atttempt is finished in Moodle

• Expand the Examus side panel and click on Finish exam at the bottom of it.

Then close the exam tab (in your browser).

Open a new browser tab. There, launch Examus (from your LMS). Select the next exam from the list of available ones.